Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer

Took ages aligning this aftermarket eng bay vent.
It was sitting too close to the edge of the boot lid yet if I try to allow enough clearance, it will hit the rear hatch glass……
Set at the best compromise.

...

Updated 19-11-2015 at 04:54 PM by Kaz-kzukNA1

Tags: defrost panel, eng bay, eng bay duct, eng bay vent, illumination control unit

Categories

Body , Electronics

Not much to report while putting the Eng back in place.





Gave good cleaning inside the eng bay.



...

Tags: cl slave cyl, coolant pipe, eng bay, eng installation, fuel filter, gbox gnd cable, pcv valve

Categories

Eng Refresh Stage 1 + LMA

3 x new coolant hoses replaced and dressed although you won’t be able to
see them later as they are going to be under the header tank.....




Lots of dust, gunk, etc inside the engine bay so gave good cleaning. ...

Tags: coolant hose, eng bay, eng installation, eng removal, fuel filter

Categories

TB/WP/Valve Service

It is very unlikely that the engine will be out of the engine bay again
for another 10 years so gave a good cleaning inside there.




Much easier to replace the fuel filter while the engine is out.
Brown coloured ...

Tags: crank end seal, end seal, eng bay, engine bay, exh gasket, exhaust gasket, flywheel, fuel filter, oil pan, sump pan

Categories

Eng Refresh Stage 1 + LMA