Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer

It is very unlikely that the engine will be out of the engine bay again
for another 10 years so gave a good cleaning inside there.




Much easier to replace the fuel filter while the engine is out.
Brown coloured ...

Tags: crank end seal, end seal, eng bay, engine bay, exh gasket, exhaust gasket, flywheel, fuel filter, oil pan, sump pan

Categories

Eng Refresh Stage 1 + LMA

Although this needs to be replaced again when the owner
puts back the CAT, new OEM gasket at the front exh pipe.

Forgot to order another one for the rear but as it's going to be
short life before putting back the CAT, just squashed the existing one
in cross direction to fatten it so that it ...

Tags: eng installation, eng mount, eng removal, engine bay, engine installation, engine removal, exhaust gasket

Categories

Eng Refresh Stage 1 + LMA

Is your cam shaft cap area clean as this???








New gasket at the CAT mating flange.







...

Tags: cam cap, engine bay, engine installation, exhaust gasket, fuel filter, timing belt

Categories

TB/WP/Valve Service

Finally, the heavily corroded stud bolts at the front CAT came off.

Thank you to member PeterW for sharing his past experience.

Based on his advice, I wanted to use the hammering feature of
the power drill to push out the remaining stud bolt stuck inside the
flange, but due to the fact that the flange was also heavily ...

Updated 24-09-2012 at 10:06 AM by Kaz-kzukNA1 (Revised blog category.)

Tags: cat stud bolt, engine bay, engine removal, fuel filter, stud bolt

Categories

Eng Refresh Stage 1 + LMA