View RSS Feed

Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background

Testing description section.

  1. Final Touch

    by , 23-03-2014 at 05:41 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)




    The owner wanted me to take a look at the cabin noise.
    One of the cause was the rattling boxes and wires behind the
    centre console around the heater unit.

    Normally, I’m quite happy to disconnect any connectors and
    re-rote the cables but as these could be for the security devices,
    it is too risky for me to just start disconnecting any of the connectors
    without knowing the system architecture or wiring diagram.

    ...
  2. A/C CCU Board service

    by , 23-03-2014 at 05:30 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)




    Although the owner was not feeling any issues on his A/C system,
    he decided to carry out the preventative measures on the CCU.
    Very good decision by acting now instead of waiting for something to fail
    as it will save the time and cost for the owner.




    The light green circuit board material with brown capacitor
    ...
  3. Eng Refresh 25

    by , 23-03-2014 at 05:20 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)




    Went out for the 1st test driving session for the general checks.

    Happy with the result so back on the lift, visual inspection,
    re-torque the wheel nut, adjust the Aux belts tension, etc and
    checked the base idle rpm.




    This is the DBW model so needs to short the 2pin Blue SCS terminal
    before
    ...