View RSS Feed

Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background

Testing description section.

  1. ABS Upgrade, Door Window Refresh, etc 11

    by , 08-06-2015 at 03:47 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)








    Hm…. It’s dirty but you don’t want to apply any force in this area especially around the linkage and the plastic fasteners.
    Removing the rod from the linkage is easy if you know the trick but it’s time consuming
    ...
  2. ABS Upgrade, Door Window Refresh, etc 10

    by , 08-06-2015 at 03:41 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)











    European spec high pressure washer motor, grommet, seal sponge. The old motor was still active but lost pressure so already partially dead.

    Washer tube held with new bracket.
    ...
  3. ABS Upgrade, Door Window Refresh, etc 09

    by , 08-06-2015 at 03:24 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)










    ...
    Categories
    Body
  4. ABS Upgrade, Door Window Refresh, etc 08

    by , 08-06-2015 at 03:11 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)










    I’m not going to bother repairing this protective sheet again….

    Will clean the old OEM white sticky sealant and replace the sheet.

    However, later, I found that addition to the black butyl sealant, someone used double sided tape under there.

    It was a nightmare removing them
    ...
  5. ABS Upgrade, Door Window Refresh, etc 07

    by , 08-06-2015 at 02:53 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)








    Started working on the Door window refresh from few days ago.

    Normally, you would take some video to show before/after of the refresh but there was not much point as the owner couldn’t even lower the window if the door was closed at the left side.
    The right side was somewhat better but I found out that someone already worked in the door section in the past and touched the window alignment so not relevant.
    ...
    Categories
    Body