View RSS Feed

Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background

Testing description section.

  1. Health Check, Brake OH, Koyo Rad, etc 18

    by , 14-11-2015 at 10:39 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)

    One of the reason why extra time was required on this occasion.
    On arrival, the ABS fluid level was well below the MIN line so I knew there was some issues but turned out, three out of four ABS solenoids had issues.




    Two
    ...

    Updated 19-11-2015 at 04:55 PM by Kaz-kzukNA1

    Categories
    ABS Original
  2. Abs

    by , 21-11-2012 at 10:28 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)


    Following on from yesterday,
    still working on the two solenoids that were completely stuck closed.

    After lots and lots of attempts, finally both of them started to
    release the fluid back into the reservoir.







    Before this, flushed the accumulator twice as my standard procesure.
    It was
    ...

    Updated 23-11-2012 at 02:22 PM by Kaz-kzukNA1

    Categories
    ABS Original
  3. Abs

    by , 19-10-2012 at 10:37 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)








    This NSX is equipped with2nd generation type so its design is far better than
    the 1st gen type against the leaky solenoid issue.

    However, for any classic ABS model, the accumulator is another weak point and
    on this NSX, it seems that the nitrogen gas in the accumulator is
    slowly leaking as I extracted
    ...
    Categories
    ABS Original
  4. Annual Service + Audio Head Unit 05

    by , 21-09-2012 at 10:07 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)




    Continuing with the Health Check and ABS…….





    All four solenoids operated fine so no drama here.









    This is the 2nd generation ABS so the ...
  5. Brake OH 02

    by , 17-09-2012 at 10:39 PM (Today at Atelier Kaz - Private NSX Enthusiast, ex-Honda R&D engineer with F1, Indy/CART background)






    Just a follow up for the last post.
    Photo of the Goodridege custom made brake line.









    The replacement master cyl.




    ...
Page 1 of 2 12 LastLast