View RSS Feed

Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer

Updates from Kaz-kzukNA1

  1. Kaz-kzukNA1's Avatar

    Eng Refresh, Cooling Sys, etc 23

    by
    Kaz-kzukNA1
    , 13-09-2018 at 02:26 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)












     ...
    Categories
    Eng Refresh Stage 1 + LMA
    Comments 0 Comments
    Read MoreRead More
  2. Kaz-kzukNA1's Avatar

    Eng Refresh + LMA, Health Check, etc 36

    by
    Kaz-kzukNA1
    , 17-09-2017 at 07:44 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)















    ...
    Categories
    Eng Refresh Stage 1 + LMA
    Comments 0 Comments
    Read MoreRead More
  3. Kaz-kzukNA1's Avatar

    Eng Refresh + LMA, Bilstein Damper, etc 18

    by
    Kaz-kzukNA1
    , 05-04-2015 at 12:53 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)








    After cleaning the cyl head as much as possible, new o-ring under #1 cam holder installed.

    Before applying the liquid gasket, the mating surface should be cleaned to this level.


     ...
    Categories
    Eng Refresh Stage 1 + LMA
    Comments 0 Comments
    Read MoreRead More
  4. Kaz-kzukNA1's Avatar

    Eng Refresh + LMA, Bilstein Damper, etc 17

    by
    Kaz-kzukNA1
    , 05-04-2015 at 12:45 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)







    The LMA at the rear bank replaced, rocker shafts and arms back in place after cleaning.

    As reported earlier, had to replace both sealing bolts for this bank.



     ...
    Categories
    Eng Refresh Stage 1 + LMA
    Comments 0 Comments
    Read MoreRead More
  5. Kaz-kzukNA1's Avatar

    Eng Refresh, Health Check, etc 24

    by
    Kaz-kzukNA1
    , 04-02-2015 at 01:02 PM (Today at Atelier Kaz - ex-Honda R&D, F1, Indy/CART engineer)











    This is how the liquid gasket should be applied if the cam shaft was removed and     ...
    Categories
    TB/WP/Valve Service
    Comments 0 Comments
    Read MoreRead More
Page 1 of 3 123 LastLast