Upper windscreen moulding

[mutley]

Hi all,

Does anyone have a good part number for the little rubber strip that goes across the top of the windscreen? Or just happen to have a new one lying around that they never used?

Cheers
Jim

[Hagasan]

Hi all,

Does anyone have a good part number for the little rubber strip that goes across the top of the windscreen? Or just happen to have a new one lying around that they never used?

Cheers
Jim

Hi Jim,

have a word with Simon. I think he can help?

Cheers,

Gary

[NSXGB]

Parts 5 & 6 on this link: https://www.lingshondaparts.com/honda_car_parts_selection.php?block_01=17SW001&block_02=B__5200&block_03=21810&block_05=hcr

I have a spare outer but you'd need both parts.

How's your windscreen looking? If you are planning on getting a new windscreen in the near future, those parts would be replaced by the windscreen company....

[mutley]

The windcreen is perfectly fine, but the original moulding needs replaced (currently taped in place!)
I was aware the new version was in 2 parts, so I guess I'll have to go to Honda.

Jim

[Kaz-kzukNA1]

Hi, Jim.

You need these two parts as in NSXGB’s post.



https://lh3.googleusercontent.com/-wSffWgwiqzs/VqkQPlLRWiI/AAAAAAAAdxU/TxYxlBPpCZw/s800-Ic42/201601_001.jpg

https://lh3.googleusercontent.com/-piDrYqxb17k/VqkQRqluKDI/AAAAAAAAdxU/Vz2JXqFSqys/s800-Ic42/201601_002.jpg



https://lh3.googleusercontent.com/-vK7C4PXht4E/VqkQVp9WyTI/AAAAAAAAdxU/BxxsgIDwHo4/s800-Ic42/201601_004.jpg

https://lh3.googleusercontent.com/-s9svUB0aSPc/VqkQXjOYtTI/AAAAAAAAdxU/87sapa3k6Jw/s800-Ic42/201601_005.jpg
You may need to replace some of the screws and bolt used at the door opening visor. Some of them can get very rusty.
90128-SL0-003: Screw with plastic washer, should be able to re-use most of them for both sides (R & L doors) so just about 6 spare should be enough.
90130-SL0-003: The bolt with plastic washer holding the glass guide, should be able to re-use both, only one at each sides


https://drive.google.com/file/d/0B77PIkz1qVicXzA4bVJGWkdTSG8/view?usp=sharing
Useful information from TSB.


Some example from my blog;
http://www.nsxcb.co.uk/entry.php?1665-Health-Check-Brake-OH-Koyo-Rad-etc-19

http://www.nsxcb.co.uk/entry.php?1013-Interior-noise-04


The key is the preparation and clean the area as much as possible.

If you are in Bucks and having difficulty in getting the parts, please visit my place.
I have 2 sets of the above fastener and molding but I'm using the 1 set right now.


Kaz