Activity Stream

Looks like Honda UK have updated the press car Olly

The order arrived and the length of 408 mm (130 mm diameter) fits perfectly. Interestingly, the old belt is a little thicker than 1 mm, probably 1.2...

Thank you very much but that's definitely too much praise .. In my opinion .. :)

No idea yet still in the planning stage.

CliveYag, I have sent you a message

A new "Kaz" was born to us ..... A very factual article

Very good write up Heineken, particularly the diagnostic test procedure. Thanks.

Hi Mike, could I take the remaining place, if it is still available. Many thanks Clive

In this case, I'm going to order the 408 mm first as it's a separate distributor anyway. I'll keep you updated about the results :)

I have just made this conversion to my car and yes it is just a case of plug and play with the correct harness's. Ensure installing new light unit...

JDM also has 4 brake lights too.... UK, EU lights are in the offside reversing light position ( side depending on region!! )... Except mine, didn't...

Over time they stretch by about 5-10% but not 20%. 408 mm night be a good starting length.

Just a hint when using the JDM tail light: It's possible to convert one of the two white reverse lights into a fog light by installing a (same...

Thanks for the hint. Unfortunately I made a mistake when measuring the belt, it's actually 425 mm. It looks like even the Nakamichi does not utilize...

Try to get hold of Nakamichi spare parts on eB. They might have a similar one. 220 mm is the length after stretching over the years. It's maybe 200...

Hi, Mark. You don't need the test harness. The electrician should be able to figure out the system diagram in the workshop manual. If you...

Pencil me in if there's room!! Tho I'll have to pay the ulez ransom!!!!

Guessing that is in the wrong thread, can an admin do their thing??? Ta muchly

Without an airbag there should be a resistor instead of it. There's no fuse within the SRS unit. But the caps do go bad within the unit and the can...

Hi I am not aware it has been rebuilt in the past.Is there a fuse within the SRS module itself ? I dont know much about it hence I'm using a auto...

Has the SRS module been rebuilt in the past? Fuse ok?